Rustic TV stand can be expensive. Building a simple wooden stand can be done for less cost and done according to your preferences. A two-piece wooden TV stand supports most TVs and allows room for movie or gaming systems. Consumables and wood needed to create a wooden TV stand can be purchased in construction markets. Hardware and tools can also be purchased at hardware or discount stores.
Stand the top portrait so the 43 1/2 inch border is horizontal. Place a side piece (19 inches long vertical) below the top piece so that they flush form a large L. This is the top and left side rack. Then you will attach the left side to the top. Face the top piece. Measure 1 inch down from the top left corner and 1/2 inch from the top is outside the left edge. Mark with a pencil. Use a drill with a screwdriver piece to attach a screw through the pencil mark. You will attach three screws through the top of the top of the side piece.
Measure 1 inch up from the top bottom left corner and 1/2 inch from the top is outside the left edge. Screw a wooden screw through the top piece and in the top edge of the side piece. Measure from the first screw, down 11 inches and 1/2 inch from the outside edge. Screw a screw through the top into the upper edge of the left side. That tree L now has three screws. Measure 21 1/2 inches horizontally from the attached left side, to the right. Make a pencil mark under the top piece. Adjust the divider piece with the pencil labeled, so the position resembles a capital F. Screw the wood screws through the top piece and into the divider piece top edge. Adjust the remaining side flush with the right edge of the top piece that constitutes a capital E. Face the top piece. Measure 1 inch down from the top right corner and 1/2 inch from the top is outside the right edge.